Products�?¢â??�?¼

Home » Services » Hose Assembly

Hose Assembly Service

http://www.powellindustrial.com.au/libraries/images/About Us Section/POWWEB_Services_Assemblies.png

Our specialty is the supply of fitted hose assemblies that are tagged, tested and implanted with an RFID Microchip. All of our hose assemblies are built to the relevant NAHAD or Australian Standard, to ensure total compliance to every state’s legislation.


ON-SITE TESTING: Testing Procedures

VISUAL INSPECTIONS
Focusing on:
•    Mechanical damage
•    Corrosive damage
•    Wear and tear occuring during installation, use or storage.
•    Kinks, loose covers, bulges or ballooning, soft spots, cuts, broken wires or any obvious defect in the hose.
•    Fittings and attachments inspected for any visual defect that may affect performance of assembly.


HYDROSTATIC PRESSURE TESTING
After a visual inspection, hose is pressure tested to its test pressure using recycled water, with compressed air used for stainless steel hoses. Powell Industrial can test up to pressures of 3000 psi (207 Bar). Pressure testing takes the hose up to the test pressure specified by the manufacturer (usually 1.5 times maximum working pressure). Tests are conducted in accordance with Australian Standards for a minimum of 1-2 minutes.


VACUUM & SUCTION TESTING
Vacuum testing is conducted at Powell Industrial to ensure that any hose we build for vacuum or suction purposes will perform efficiently and reliably in its intended application. All hose assemblies built at Powell Industrial that are subjected to either vacuum or suction applications are tested in strict accordance with Australian Standard AS 1180 7J & NAHAD Standards.


REQUIRE AN ASSEMBLY? WE CAN ASSIST.

Contact us for assistance with estimating and building a custom hose assembly or use our Hose Assembly Form and submit your requirements to us.